Threaded Cylinder jack dimensions

Discussion in 'Pickups, Electronics & General Tech' started by Rattlehead83, Apr 9, 2018.

  1. Rattlehead83

    Rattlehead83 SS.org Regular

    Messages:
    206
    Likes Received:
    277
    Joined:
    Aug 2, 2017
    Hello, I want to know the width of this kind of jack as I'm making a custom guitar and don't know what bit to use to make the hole.
    41T4Wr-tVQL.jpg
     
  2. Rattlehead83

    Rattlehead83 SS.org Regular

    Messages:
    206
    Likes Received:
    277
    Joined:
    Aug 2, 2017
    By my photoshop size checking I've found out that the tube is around 11 mm and the end is 16 mm. But is that right? :))
     
  3. KnightBrolaire

    KnightBrolaire only the dead have seen the end of GAS

    Messages:
    16,319
    Likes Received:
    17,871
    Joined:
    Mar 19, 2015
    Location:
    Merica
    contact the manufacturer or seller and ask for dimensions. it's way easier to verify that way. worst case if they can't help you - you can buy the jack and then base the size of the hole you need to drill since it's right there in front of you irl.
     
    ElRay likes this.
  4. Rattlehead83

    Rattlehead83 SS.org Regular

    Messages:
    206
    Likes Received:
    277
    Joined:
    Aug 2, 2017
    Already contacted the seller, but they usually respond in a day....
    The jack will arrive in like 2 weeks, until then I'll have the guitar finished.
     

Share This Page