Separate names with a comma.
I've got one of the wide G&W ones, well worth the price and shipping wait.
Fretfind does give you the calculated bridge angle, but not in a direct way.... take the number listed in the red box, subtract it from 180....
Thanks! I don't have a CNC, though I do occasionally have my fretboards done on one.
Thank you so much! I suppose this'll fit into the 2017 thread since it was started way back then ( :P ), I just finished it today. -Specs- Ash...
You'll have to play around with splines rather than polylines. You'll get better visual flow (and chamfer/fillet performance) once you get it down.
Just buffed the oil off of this single-hum Wayfarer, I'm definitely digging it! [ATTACH]
Neck carve is about 90% done, just down to detailing and little refinements. [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
It's a leveling beam that adjusts to match the bow of a neck that's strung up and in proper relief. I have one. It's cool and it works, but it is...
Dots and frets are done, looking forward to the neck carve! [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH]
Feels good! The body is down to sanding now, looking forward to getting frets installed and neck carved. [ATTACH] [ATTACH] [ATTACH] [ATTACH]...
I'm alive! Though I don't post here nearly as often as I should. On the the bench today: ash body, pau ferro neck and fretboard. This one is...
Is it weird that the thing that bothers me most is the extra finger? Like... the whole thing bothers me, but that puts it over the top lol
Just picked up some nice mahogany and the coolest ash I've ever seen. [ATTACH] [ATTACH]
Limited edition, yo ;)
It's definitely the toughest wood I've found! Rock hard, resistant to cutting, splinters like a bastard. On the plus side... it looks amazing and...