PRS Replacement Potentiometers

Discussion in 'Pickups, Electronics & General Tech' started by TedintheShed, Feb 11, 2019 at 12:43 AM.

  1. TedintheShed

    TedintheShed Retired bassist pretending to play guitar

    Messages:
    686
    Likes Received:
    396
    Joined:
    May 3, 2013
    Location:
    Columbus, Ohio
    I have a PRS Wood Library Custom 24 Floyd that I am replacing the pickups for a set of 4 conductor Warpigs. I want to order replacement potentiometers. I want a push-push for the coil split- will I require a long shaft potentiometer or a short shaft potentiometers?

    Thanks,
    Ted
     
  2. KnightBrolaire

    KnightBrolaire schadenfreude

    Messages:
    10,173
    Likes Received:
    7,468
    Joined:
    Mar 19, 2015
    Location:
    minnesotahhh
    cts or bourns both make good quality pots. even OEM stuff like alpha is fine. check ebay or allparts.
     
    TedintheShed likes this.
  3. TedintheShed

    TedintheShed Retired bassist pretending to play guitar

    Messages:
    686
    Likes Received:
    396
    Joined:
    May 3, 2013
    Location:
    Columbus, Ohio
    The pots I'm ordering are CTS- I just need to know if I need long shaft or short shaft for the PRS before I do.
     
  4. KnightBrolaire

    KnightBrolaire schadenfreude

    Messages:
    10,173
    Likes Received:
    7,468
    Joined:
    Mar 19, 2015
    Location:
    minnesotahhh
    measure the old ones.. you can double check that info on stewmac or allparts since they post dimensions/specs.
     

Share This Page