Pedal Board Signal Chain Help

Discussion in 'Gear & Equipment' started by Moe110, Sep 4, 2016.

  1. Moe110

    Moe110 SS.org Regular

    Messages:
    44
    Likes Received:
    28
    Joined:
    Jun 28, 2012
    Location:
    Brisbane
    Yo pedal nerds :D ive managed to get myself (back) into pedals/boards so I need some help. This is my current set up (please ignore the signal chain as this was just the basic test run).
    What I want to do is run the Sentry 100% of the time and use the mojo mojo and flashback as a boost and fill during the leads and solo section to fill the mix out. I want to somehow engage these two pedals by using the Bigshot ABY pedal.....I simply dont know how to lol Ive had a couple of people say run the delay in the amp loop and run the OD 100% of the time (which i will and still yet to try) but i would prefer to to activate them both as a section boost.

    Feel free to save the pic and draw your signal paths ;)
    Any help is always appreciated!
    [​IMG]
     

Share This Page