Need help with MojoTone CTS pot wiring

Discussion in 'Pickups, Electronics & General Tech' started by LeviathanKiller, May 11, 2018.

  1. LeviathanKiller

    LeviathanKiller Knee-shooting Archer

    Messages:
    959
    Likes Received:
    331
    Joined:
    Aug 24, 2010
    Location:
    In that shadow over there -->
    How do you wire TWO humbuckers to be coil-split by one of these?
    I purchased one of these MojoTone CTS DPDT Push-Pull pots. There's only one wiring diagram I found which doesn't answer my question.

    Maybe this makes sense for the more electrically inclined
    [​IMG]
     
  2. LeviathanKiller

    LeviathanKiller Knee-shooting Archer

    Messages:
    959
    Likes Received:
    331
    Joined:
    Aug 24, 2010
    Location:
    In that shadow over there -->
    This is what it looks like
    [​IMG]
     
  3. cardinal

    cardinal Strat 7 Guy

    Messages:
    4,234
    Likes Received:
    1,207
    Joined:
    Mar 6, 2007
    Location:
    Northern Virginia
    So I’d probably wire one pickup’s coil-split wires to C1 and the other to C2. Then ground 1 and 3. That would split both when the knob is pulled.

    Make the connections into those larger eyelet holes.
     
    LeviathanKiller likes this.
  4. LeviathanKiller

    LeviathanKiller Knee-shooting Archer

    Messages:
    959
    Likes Received:
    331
    Joined:
    Aug 24, 2010
    Location:
    In that shadow over there -->
    I was kinda wondering if that was it. I will try that and hope it works
    Will report back afterwards
     
  5. LeviathanKiller

    LeviathanKiller Knee-shooting Archer

    Messages:
    959
    Likes Received:
    331
    Joined:
    Aug 24, 2010
    Location:
    In that shadow over there -->
    Shaft was too big so I installed using the old pot. Will have to buy alphas for this guitar
     

Share This Page