Jackson Juggernaut tone push/pull wiring diagram

Discussion in 'Luthiery, Modifications & Customizations' started by LeoLmX, Oct 4, 2017.

  1. LeoLmX

    LeoLmX SS.org Regular

    Messages:
    10
    Likes Received:
    10
    Joined:
    Nov 10, 2015
    Location:
    Brazil
    Hey everyone.

    I'm building a guitar with my luthier and I wanted the pickup configuration to be the exact same as the Jackson Juggernaut Misha Mansoor signature. I bought a slanted version of the Juggernaut pickups for the added effect.
    It's easy to find the wiring diagram for the configurations on that guitar using a super switch, the problem is the tone knob. It has a push/pull that when its pulled, the tone knob works as a tone knob and when it's pushed it acts as a bypass. I couldn't find this wiring scheme anywhere on the internet. Could you guys help me out with that?

    thanks!
     
  2. Lemonbaby

    Lemonbaby SS.org Regular

    Messages:
    304
    Likes Received:
    108
    Joined:
    Jun 3, 2015
    Location:
    Germany
    You solder the signal wire (from volume pot) to the middle pin of the switch. The upper pin of the switch is connected to the left pin of the tone pot.
     
  3. LeoLmX

    LeoLmX SS.org Regular

    Messages:
    10
    Likes Received:
    10
    Joined:
    Nov 10, 2015
    Location:
    Brazil
    Oh it's that easy?
    I was also considering a no-load tone control for the ease of instalation and the effect would be the same.
     

Share This Page