Has anyone got a fernandes revolver or revolver 7 with sustainer?

Discussion in 'Pickups, Electronics & General Tech' started by 7 Dying Trees, Oct 21, 2008.

  1. 7 Dying Trees

    7 Dying Trees Forum MVP

    Messages:
    9,937
    Likes Received:
    1,727
    Joined:
    May 6, 2004
    Location:
    7th Ethereal Plane of interstellar hell, Innit Bru
    I have a favour to ask, if someone does, and that is if someone can take a picture of the board, and connectors for it. I think I have figured one or two out, but don't know what most of them are for...

    Need help, as the board I've got is not the one they sell to retrofit other guitars (ie, NOT the fsk-101 or fsk-401)

    The board does have one identifier, TS-PCB-B and is ver 1.0a

    Any help would be good!

    I have already figured out via some logic that the two pin connector is the on/off switch, whereas there is what looks like 2 wires into a 4wire plug which I think is the battery connector, but am not entirely sure.

    So if anyone could be kind enough to taker a picture of one inside their guitar (even better if it is from both sides) then that'd be very very cool.

    I know it is a long shot though...
     
  2. Vairocarnal

    Vairocarnal ...is something.

    Messages:
    401
    Likes Received:
    11
    Joined:
    Feb 25, 2007
    Location:
    Origin
    Hey man, any luck with this yet.
     
  3. 7 Dying Trees

    7 Dying Trees Forum MVP

    Messages:
    9,937
    Likes Received:
    1,727
    Joined:
    May 6, 2004
    Location:
    7th Ethereal Plane of interstellar hell, Innit Bru
    Well, i got a circuit diagram now, but have a slight issue in that I have no idea how the selector switch is wired,k it's the one bit of the puzzle i haven't got. Basically I need to know what the switch that fernandes use does internally, after which I can then figure out how to wire it on a non proprietry switch...


    Getting closer though!
     

Share This Page