[Atomic_gerbil]

1 just now ordered

BTW, does people who bought both stickers and t-shirt get some extra credit now ???
Or are we just contributors ?

[Steve]

Matt and Mike.... Your stickers are on the way!

[Atomic_gerbil]

[yevetz]

Got mine......Thanks Steve

http://www.sevenstring.org/forum/off...tml#post711685

[Michael]

When I got mine, I didn't realise that each letter was seperate. So I ended up having to stick a couple of the letters on individually after I'd figured out how to properly stick the sticker on. Silly me.

[g3rmanium]

Sent money for five over!

[Steve]

Originally Posted by Michael

When I got mine, I didn't realise that each letter was seperate. So I ended up having to stick a couple of the letters on individually after I'd figured out how to properly stick the sticker on. Silly me.

Just in case you had any questions:

You should read these instructions all the way through before starting.
The surface must be clean, and free of all oils, waxes and dirt. Use windex or a comparable cleaner to clean the glass. If you use rainex, try formula 409 to remove it.
These decals come to you in three layers. The top layer is called transfer tape. It looks somewhat like regular masking tape. The middle layer is the actual decal. The bottom layer is a backing paper treated with a release agent.

Application using the Dry Transfer Method:

You will need a credit card or similar plastic squeegee.
Try to do at room temperature or above, the warmer it is, the better it works, but try not to do in direct sunlight.
Take credit card and flatten from both sides by rubbing over decal. Make sure all bubbles are out as much as possible. Turn decal upside down and pull backing off, SLOWLY. The backing is the heavier gauge paper.
Position decal and flatten from the center out. Use credit card again to flatten as much as possible. The transfer tape will allow you to
rub the Decal without damaging it.
Peel back edge of transfer tape slowly, watching for small letters and corners to make sure they are stuck to glass, and not to tape.
Take your fingers and check all edges and make sure they are tight. If you have an air bubble, use a pin and poke a small hole, allowing air to escape. The bubbles may disappear after a day or two.
Once the decal touches the glass or paint, it cannot be moved again!

[s7eve]

Thanks Steve, mine turned up the other day.

[Atomic_gerbil]

Got mine today, nothing short of total badass! Thanks Steve!