[heffergm]

Dimarzio doesn't offer a wiring diagram with the typical Carvin coil splitters show in the loop, so I'm still lost.

Here's what I see:





I was told this, but it doesn't quite seem to add up:

BRIDGE: Red Hot to selector switch. Black and White solder together going to your coil splitter switch, solder them where the lead(s) from your old pickup went on that switch. Green to ground, usually soldered to the casing of the volume pot.

NECK: White hot to selector switch. Green and Red soldered together and going to the coil splitter switch. Black to ground.

Can anyone confirm this:?

Like this:

[ibznorange]

Ok, what you wanna do, is just rip all the wiring out, and start over

here is a diagram for a coil split

Wire up each pickup to that diagram. Then, using the red output of those switches, wire it up by the dimarzio wiring diagram you want with the 3 way.