[Alpo]

Unfortunately, I now have to have 300€ extra for pickups when I buy another guitar.

[7 Dying Trees]

Originally Posted by Alpo

Unfortunately, I now have to have 300€ extra for pickups when I buy another guitar.

Tell me about it, I now want to do all the others :/ Not cheap :/

[halsinden]

Originally Posted by 7 Dying Trees

The push pull pot isn't too hard to do to be honest If you get the 5-way wired up, then it's just adding 4 wires, and moving two and you're all done for the coil split

It is SO worth it though

so dude, does this mean you'll do the fittings when i get my nailbombs?

H

[7 Dying Trees]

Originally Posted by halsinden

so dude, does this mean you'll do the fittings when i get my nailbombs?

H

Yeah, not too hard to do. You get nailbomb for the neck as well? WOuld quite like to hear what that's like in the neck. Love the bridge one

[halsinden]

Originally Posted by 7 Dying Trees

Yeah, not too hard to do. You get nailbomb for the neck as well? WOuld quite like to hear what that's like in the neck. Love the bridge one

well, only that it's what tim prescribed for what i was asking (good distorted tone, but also clear for clean work which i'll be doing a lot of). would you suggest otherwise for the neck?

by the way, how much should i prepare for re the push/pull pot change and the selector switch?

H

[7 Dying Trees]

Originally Posted by halsinden

well, only that it's what tim prescribed for what i was asking (good distorted tone, but also clear for clean work which i'll be doing a lot of). would you suggest otherwise for the neck?

by the way, how much should i prepare for re the push/pull pot change and the selector switch?

H

I dunno, I just went and copied chris brodericks supposed setup with a cold sweat for the neck. Absolutely lucious, it really is, but to be honest, if you tell tim what you want, you'll get it. First set of bareknuckles i've had, so it's a new (but very cool) thing.

3(or however much the things cost me)£ for the push pull pot, and no other preperation required, i have all the tools and it should be a relatively quick job. I think. Basically I'll have to figure out the switch, wire that, then add in the push pull and it should all be fine!