flo

It's a long-shot, but do you still have that Nordic 8 ?

Tach Tach

Indeed.

It is precisely why I choose the recto for my uses.

Posted a clip just for you, man. :p

Yeah, I'll order the pieces and try it out first, we'll see if it holds up :o

I'm not sure if I can get my hands on anything amazing, it seems the largest I could go would be 1.3mm and hope that it shows up on the front and sides, I could use a small saw or chisel to make it fit right?

Thank you Flo!
Using a smaller piece to correct uneven fretting seems about fine to me! Now I can save money on a fret hammer
Just out of curiousity, do you think inlaying a piece of pearl into the side to count as a side marker/fret marker would work?

Hiya Flo, I understand you are in germany and probably asleep right now, but i'd like to ask about the fret pressing. Since I haven't the resource for a plastic hammer, I've thought of using the vice at my school's woodshop (there are vices on every table), and well, they're a bit bigger than the one you had pictured in my thread. I was wondering if it was possible to just press the whole fret in at once, using a piece of maple to cushion the fret so it isn't dented by the vice, would be a good idea. Since the walnut neck will be carved afterward, I don't think letting it touch the vice will hurt, if at all. Looking forward to your response!

-Tommy

So viele selbstgemachte gitarren, ich kanns nicht verstehen

Neightbours! Woooow so near ehem.. so nah