Sevenstring.org - View Single Post

Emiliano · 09-12-2007, 04:49 PM

hi regor!

i posted a circuit very similar to what you need
and i repost here to you

with just one consideration

IMHO a pushpull switch doesn't have the right amount of poles
to give you exactly the

state1=> tone with vol on 10
state2=> volume with tone on 10

i tryied to figure it out but it seems that i'm missing just a pole

however my design allow you to

state1=> tone with vol on 10 ( just like you wanted )
state2=> volume without tone ( a bit more brighter )

and here it is!

always IMO
i think that the comparison would be useful if you still have
the older sound " without tone "

this way you'll have just an added feature
and no added work to do

I.E.
when i took out the tone pot just to try what effect would it have
i found myself not liking because of the added brightness

i had to rewrite some patches and change some eq ( long and boring times )

but then i started to like what i was hearing
( much more cut in the mix especially on clean sounds )

ATTENTION

i wrote " state1 and state2 " and not " push and pull "
because it depends how you do the wiring! so be careful!

hope you liek!

09-12-2007, 04:49 PM	#5
Emiliano true DJENTleman Join Date: Nov 2005 Location: rome_italy Posts: 305 Real Name: Emiliano Main Seven: RG1527X Rig: Vtwin>gx700>mesa2020 Thanked: 6	hi regor! i posted a circuit very similar to what you need and i repost here to you with just one consideration IMHO a pushpull switch doesn't have the right amount of poles to give you exactly the state1=> tone with vol on 10 state2=> volume with tone on 10 i tryied to figure it out but it seems that i'm missing just a pole however my design allow you to state1=> tone with vol on 10 ( just like you wanted ) state2=> volume without tone ( a bit more brighter ) and here it is! always IMO i think that the comparison would be useful if you still have the older sound " without tone " this way you'll have just an added feature and no added work to do I.E. when i took out the tone pot just to try what effect would it have i found myself not liking because of the added brightness i had to rewrite some patches and change some eq ( long and boring times ) but then i started to like what i was hearing ( much more cut in the mix especially on clean sounds ) ATTENTION i wrote " state1 and state2 " and not " push and pull " because it depends how you do the wiring! so be careful! hope you liek! "The man in black fled across the desert and the gunslinger followed......." "Because as everyone knows, tone is directly proportional to the amount of blinky lights that you have in your rack!" - The Adminishredder - JJ is my hero!