Quote:
Originally Posted by scott from _actual time_  yep. here's a maple V that i did with similar products: 
some things to consider:
what kind of wood is it? maple stains well. alder stains OK but can be patchy. closed-grain woods like maple and alder also give a nice smooth finish without using any pore filler, but open-grained woods like ash and mahogany have pores that will leave pits in the final finish if you don't fill them first.
that Stew Mac tutorial is a good starting point, but always test on scrap wood, preferably the same kind as your guitar, or even chunks of the same exact piece of wood. test your stain at different concentrations, test leaving it on the wood different amounts of time before wiping it off.
that Stew Mac lacquer is nitrocellulose. most Lowes stores carry Deft brand nitrocellulose, which is just as good but cheaper. definitely buy a mask with filters that will filter out organic vapors--nitro is very nasty shit that will eat away your lungs if you breathe it. only spray in a well-ventilated area, like outside.
i use 1-2 cans of sanding sealer, then 4-6 cans of lacquer--gloss on that V. you will also need fine-grit sanding papers--the micro-mesh ones are very good. Stew Mac sells them, but Woodcraft sells them for cheaper.
and the forums at projectguitar.com are a great resource for all things about guitar building. |
awesome information man!!
the wood, i believe, is actually alder. It's not the prettiest grain in the world but i think it will do ok.
i stripped the guitar down to the bare wood so will i need to use sealer or anything before i start painting?